Sale

Digital Signal Processor SYMETRIX RADIUS NX 12×8

อุปกรณ์ปรับแต่งสัญญาณเสียง SYMETRIX RADIUS NX 12×8 Audio connections include 128 (64×64) channels of redundant Dante, 12 analog mic/line inputs, 8 analog outputs, and USB audio. Support for Radius and Edge Expansion Cards

ราคาสินค้าไม่รวมภาษีมูลค่าเพิ่ม

฿140,000.00 ฿126,000.00

สอบถามและสั่งซื้อสินค้า

Description

SYMETRIX RADIUS NX 12×8 Digital Signal Processor

อุปกรณ์ปรับแต่งสัญญาณเสียง SYMETRIX RADIUS NX 12×8 Audio connections include 128 (64×64) channels of redundant Dante, 12 analog mic/line inputs, 8 analog outputs, and USB audio. Support for Radius and Edge Expansion Cards

Radius NX 12×8 is best suited for applications requiring a greater compliment of analog input and output channels and or logic output and external control input capabilities. Audio connections include 128 (64×64) channels of redundant Dante, 12 analog mic/line inputs, 8 analog outputs, and USB audio.

Features:

  • Audio connections include 128 (64×64) channels of redundant Dante
  • 12 analog mic/line inputs, 8 analog outputs
  • 8×8 channels of USB audio
  • Ultra-low noise preamps with 3 dB gain steps.
  • USB audio port enables soft-codecs + record/playback.
  • Dedicated routing resources for a 128×128 Super Matrix.
  • 4-port Gigabit Switch serves Dante + control networks
  • Support for Radius and Edge Expansion Cards

Specifications

General Specifications

Processor 1 x Analog Devices Griffin ADSP-SC587 dual- core DSP @ 500 MHz
Raw processing capacity 500 MIPS, 6 GFLOPS, 2 GMACS
Sampling rate 48 kHz, ± 100 ppm.
Frequency response (A/D/A) 20 Hz – 20 kHz, ± 0.5 dB.
Dynamic range (A/D/A) > 114 dB, A-weighted.
Channel separation (A/D/A) > 110 dB @ 1 kHz, +24 dBu
Latency (A/D/A) 1.04 ms, inputs routed to outputs
Delay memory 174 mono seconds.
Analog control inputs 0-3.3 VDC.
Recommended external control potentiometer 10k Ohm, linear.
Logic outputs Low (0V) when active, pulled high (5V) when inactive.
Logic output maximum external power supply voltage / current sinking 24 VDC / 50 mA.
Logic output maximum output current 10 mA.
THD + Noise < -95 dB (22.4 kHz BW, unweighted); 1 kHz @ +15 dBu with 0 dB gain
RS-232 accessory serial I/O 57.6 kbaud (default), 8 data bits, 1 stop bit, no parity, no flow control wired straight-through, only pins 2, 3, and 5 required
RS-485 serial I/O 38.4 kbaud (default) 8 data bits, 1 stop bit, no parity, no flow control. May be broken out of ARC port
Ethernet Cable Standard CAT5/6, maximum device to device length = 328 feet / 100 meters
Dante Cable Standard CAT6, maximum device to device length = 328 feet / 100 meters
ARC Cable Standard CAT5/6, distance dependent upon load and number of devices
Maximum stored presets 1000.

AEC (if installed)*

Number of Channels Up to sixteen (16) for dual-core module (up to 8 references), up to eight (8) for single-core module (up to 4 references)
Tail Length 400 mS maximum, dependent on channel and reference count
Convergence Rate Typically > 90dB/sec
Latency 11 mS
Processors 1 x Analog Devices Griffin ADSP-21584 dual-core DSP @ 500 MHz
Raw processing capacity 500 MIPS, 6 GFLOPS, 2 GMACS
*Optional coprocessor module required, single-core or dual-core models are available.

Analog Inputs

Connectors 3.81 mm terminal blocks.
Number of inputs Twelve (12) switchable balanced mic or line level
Nominal input level +4 dBu
Maximum input level +24 dBu
Mic Pre-amp Gain 0 to 51 dB in 3 dB steps with ± 24 dB digital trim
Mic Pre-amp EIN < -125 dB with 150 Ohm source impedance, 22.4 kHz BW
CMRR > 50 dB @ 1 kHz, unity gain
Input impedance 2k Ohms balanced, 1k Ohms unbalanced
Phantom Power (Per Input) +48 VDC @ 10 mA maximum.
Dynamic range > 115 dB, A-weighted.
THD + Noise < -100 dB (22.4 kHz BW, unweighted); 1 kHz @ +15 dBu with 0 dB gain.
Latency 0.31 mS

Analog Outputs

Connectors 3.81 mm terminal blocks.
Number of outputs Eight (8) balanced line level.
Nominal output level +4 dBu with 20 dB of headroom.
Maximum output level +24 dBu (+22.8 dBu into a 2 k Ohm minimum load).
Output impedance 300 Ohms balanced, 150 Ohms unbalanced.
Dynamic range > 117 dB, A-weighted.
THD + Noise < -97 dB (22.4 kHz BW, unweighted); 1 kHz, 0 dB gain +8 dBu output
Latency 0.65 mS.

USB Audio I/O

Connector One (1) high-retention Type B
Interface 2.0 with Audio class 1.0 legacy modes
Capacity 1×1 (echo cancelling speakerphone and non-echo cancelling speakerphone modes) – driverless, 2×2 line I/O mode – driverless, and 8×8 line I/O mode – driver included
Sample Rate 48 kHz
Bit Depth 16-bit, speakerphone modes; 16 or 24-bit, line modes

Mechanical Data

Space Required 1U (WDH: 18.91 in. x 9.5 in. x 1.72 in. / 48.02 cm x 24.13 cm x 4.37 cm). Depth does not include connector allowance. Allow at least 3 inches additional clearance for rear panel connections. Additional depth may be required depending upon your specific wiring and connections.
Electrical 100-240 VAC, 50/60 Hz, 60 Watts maximum, universal input.
Ventilation Maximum recommended ambient operating temperature is 30 C / 86 F. Ensure that the left and right equipment sides are unobstructed (5.08 cm, 2 in. minimum clearance). The ventilation should not be impeded by covering the ventilation openings with items such as newspapers, tablecloths, curtains, etc.
Shipping Weight 13 lbs. (5.9 kg).
Certifications or Compliance Safety: UL 60065, cUL 60065, IEC 60065 EMC: EN 55103-1, EN 55103-2, EN55032, EN 61000-3-2, EN 61000-3-3, ICES-003, FCC Part 15 (all Class A) Environmental: RoHS


โทร. : 022031821, 026414744 ext 13, 020423530
สายด่วน : 081-2399040, 084-7696296, 089-6915832

Line : @soundspacethai

หรือส่งข้อความด้านล่างเพื่อติดต่อเราทาง Facebook