ปรีแอมป์ Radial PZ-Pro, 2-channel Acoustic Preamp and DI with Phantom Power, 3 Band EQ, Switchable Filter, Piezo boost brings up your signal, FX Loop, and Wet/Dry Blend, XLR input with available phantom power on channel 2
ราคาสินค้าไม่รวมภาษีมูลค่าเพิ่ม
฿23,500.00
ปรีแอมป์ Radial PZ-Pro, 2-channel Acoustic Preamp and DI with Phantom Power, 3 Band EQ, Switchable Filter, Piezo boost brings up your signal, FX Loop, and Wet/Dry Blend, XLR input with available phantom power on channel 2
The PZ-Pro is designed for instrumentalists and performers who take a no-compromise approach when it comes to tone, both on stage and in the recording studio. Dual input channels allow you to switch between or blend together two sources, with full control over the sound of each input.
Each channel has its own semi-parametric equalizer section and input level, along with individual filter controls to reduce feedback on stage. The second channel of the PZ-Pro also features a microphone input to allow any dynamic or condenser microphone to be used, including clip-on instrument mics or even vocal microphones.
An FX Loop with a wet/dry knob provides the ability to blend in as much or as little pedal effects as desired, with a footswitch to bring them in and out of the signal chain at a moment’s notice. Finally, once your tone is completely dialed-in, balanced XLR direct outs feed the PA system or a recording interface, with both Pre-EQ and Post-EQ outputs available.
Audio circuit type: | Proprietary active circuit | |
Number of channels: | 2x Inputs, Mono Pre and Post EQ XLR balanced Out | |
Frequency response: | 20Hz-20kHz (+/-0.5dB) | |
Gain: | +20dB (Instrument Input), +55dB (Mic Input) | |
Clip Level: | +10dBu @ XLR output | |
Total harmonic distortion: | <0.005% @ 1kHz | |
Input Impedance: | 220k Ohm at input jack (10meg Ohm when PZ Boost active) | |
Output Impedance: | 1k Ohm | |
Noise: | -91dB | |
Features | ||
180° polarity reverse, Ground lift, Effects Loop, EQ Control, Boost | ||
Input Connectors: | 1/4″ instrument, XLR microphone | |
Output Connectors: | Pre and Post EQ XLR, 1/4″ Amp out | |
Extras: | 1/4″ Effects Loop, Boost, Tuner | |
General | ||
Construction: | 14-gauge steel | |
Weight: | 5.0lbs (2.27kg) | |
Shipping size (L x W x D): | 9.10″l x 5.32″w x 1.82″h (231 x 135 x 46mm) | |
Power: | 15VDC 400mA, center-pin positive | |
Conditions: | For use in dry locations only between 5°C and 40°C |